|Very Early Yaesu Musen Co. Amateur Radio Equipment in Australia|
Japanese electronics engineer Sako Hasegawa, JA1MP, established Yaesu Musen Company during 1959 in the Tokyo suburb of Yaesu. Prior to this date he had been operating a company called General Television Co Ltd in Ota-ku, Tokyo since 1956. His first SSB Equipment was manufactured under the General Television Co Ltd name in 1957. Sako Hasegawa's ambition appears to have been to design and manufacture modern HF single sideband equipment (initially transmitters) for the amateur radio market. Yaesu Musen Co's first product was a crystal controlled monoband 40 metre transmitter, the FL-10/40. Quickly following on its heels was a 5 band crystal controlled mechanical filter HF transmitter called the FL-20. Finished in grey crackle paint, it featured a built-in power supply, VOX and was only 250 x 380 x 180 mm in size. In Japan the FL-20 sold for 49,800 Yen, equivalent to approximately 62 Australian Pounds in 1963.
Japan, Australia and Germany were the first two countries to have
Yaesu Musen Co. SSB equipment available to their radio amateurs.
Bail Radio & TV Service introduced the Yaesu name to
Australia in April 1964, while Sommerkamp also started selling
Yaesu SSB transmitters in Germany around the same time. United
States radio amateurs didn't see Yaesu Musen Co. radio equipment
in their stores for another 3 to 4 years.
This web site is devoted to some of Yaesu Musen' Co's lessor known radios and the history of their introduction to Australian radio amateurs by Bail Radio & TV Service / Bail Electronic Services in the early 1960's.
is an extract from a Yaesu Musen Co. ad which appeared in
the Japanese CQ Magazine, August 1963 issue. It depicts
Yaesu's then current model crystal controlled mechanical
filter 5 band HF SSB transmitter, the FL-20 (a Mark 1
version in this case). Note Yaesu's reference to overseas
users of their FL-20, particularly VK3YS, Fred Bail, who
with his brother Jim Bail, VK3ABA, were soon to introduce
Yaesu Musen, and with it cost effective HF single
sideband operation, to the Australian radio amateur.
Although Fred Bail owned and operated an FL-20, which he
purchased from Yaesu Musen Co. while on a visit to Japan
in 1963, the FL-20, FL-20A and FL-20B were never sold by
Bail's in Australia. The author currently owns Fred Bail's original
FL-20, the very first piece of Yaesu equipment to ever come to
Australia as well as the only FL-20 ever imported into Australia to
the author's knowledge.
A partial circuit
diagram of the FL-20, its Block Diagram and photos of the
Mark 2 version and an FL-20B are shown here.
As a point of interest, Yaesu Musen Company's title was derived from the name of the Tokyo district of Yaesu, where the company's founder, Sako Hasegawa JA1MP, first started operations. Musen being the Japanese word for radio!
mid April 1964 Australian radio amateurs were able to buy
the first Yaesu radio sold in their country. Called the
FL-100B, it was a mechanical filter based 5 band HF SSB
transmitter with a built in power supply, VFO and 100
Watts PEP input. Bail Radio & TV Service sold the
FL-100B direct throughout Australia from their premises in the Melbourne, Victoria, suburb of Box Hill.
As can be seen in the ad
above, from the Wireless Institute of Australia's March
1964 issue of Amateur Radio magazine, Fred and Jim Bail
were at the time also still operating their radio and TV
repair business which they had started in 1956. It would not be long, however, before
the new Yaesu HF SSB equipment's popularity in Australia
saw the Bail's relinquishing their radio & TV repair
interests to concentrate wholly on representing Yaesu
Musen Co in Australia. The change of business direction
also accompanied a change in business name to Bail
photo immediately above is of an FL-100B Mark 2, the same
as was first offered to Australian amateurs in April
1964. Note the main tuning dial escutcheon, not provided
on the Mark 1 unit, which gave a frequency resolution of
approximately 1 KHz.
Finished in a grey crackle paint with white lettering and black knobs, the FL-100B Mark 2 (it was never officially know as the Mark 2, other than within Bail's organization) was an attractive piece of equipment to have in one's ham radio shack back in April 1964. However VFO drift, considered excessive by the Bail brothers, saw them spending many hours conducting temperature runs in a quest to alleviate the problem before allowing the transmitters to be sold.
Instuction manuals were all in Japanese, necessitating Bail's to take on the task of English translation. Once they had produced an English manual, its manuscript was sent to Yaesu Musen Co. who then had the benefit of use of it in other English speaking countries. This situation continued whenever new equipment was released, even into the early 1970's .
At this early stage of introducing Yaesu to the Australian ham, Fred and Jim Bail worked very hard in an effort to have the equipment well accepted and gain a good name. The letter below was written to an early purchaser of an FL-100B from their first Australian shipment, following its delivery, and gives an idea of the trouble taken by Bail's to achieve this end.
|Because Yaesu's early quality control program was still gaining momentum in 1964, Bail Radio & TV Service found themselves thoroughly checking every transmitter before sale, a task which also incorporated adding, for safety reasons, a 3-core power cord, Australian standard 3 pin plug as well as a slow blow fuse in the power amplifier's high tension circuit. An example of one of Bail's check notes for an FL-100B from their first Australian shipment is shown below.|
two extracts above from Bail Radio & TV Service'
Equipment Check Notes give an indication of the extent of
testing they performed on each new transmitter in order
that the equipment gain a good reputation on the
Australian market. These particular notes, dated May
1964, are for FL-100B S/N A104 which was subsequently
sold to amateur radio station VK2AHM, R. J. Whyte of Wentworth, NSW.
The transmitter had three faults which required rectification, including a dry solder joint in its electronic voltage regulator, causing voltage variation at the power amplifier valve's screen grid. Other faults were an open circuit resistor in the VFO, intermittent carrier oscillator crystal and low ALC voltage.
Modification details, such as change of diode type to remedy the ALC fault and the additional HT fuse were fed back to Yaesu Musen Co. who later incorporated these changes into their production line.
|An early purchaser of an FL-100B from Bail's first Australian shipment, R. J. Whyte VK2AHM of Wentworth in South Western NSW, is shown here in his shack operating a RL Drake 2B receiver with the FL-100B located just behind him.|
|In June 1964 Yaesu Musen Co. released their Mark 3 version of the FL-100B, the most attractive so far. It differed from its predeccsors through virtue of having a new fawn coloured case with perforated ventilation holes in place of slots, and a front panel finished in satin silver with engraved black lettering. The Mark 3 FL-100B still did not have the large VFO knob which featured on later F-Line equipment.|
early 1965 Yaesu Musen had introduced their more refined
F-Line 5 band HF SSB amateur radio station, consisting of
the FR-100B mechanical filter SSB receiver, SP-100
matching speaker, FL-200B mechanical filter 200 watt PEP
input SSB transmitter and FL-1000 1 kilowatt PEP input
The photo above shows
Yaesu Musen's founder and President, Sako Hasegawa JA1MP,
operating an F-Line station less the FL-1000 amplifier.
Sako Hasegawa passed away in 1993, Jun
Hasegawa is the company's current president.
F-Line equipment was finished in a fawn crackle paint with satin silver front panels and black engraved lettering. Knobs were either all black (on the early units) or black with silver inserts. Early quality control problems with Australian stock saw Bail Electronic Services having a number of the fawn F-Line cases re-sprayed before releasing the equipment to the Australian market.
Next Page - Yaesu Musen Co's F-Line of the mid 1960's
The author would
be happy to hear from anybody who has very early Yaesu equipment,
such as FL-20 Mark's 1 and 2, or FL-100B Mark's 1 and 2. By way
of some background information on the author, Greg Whiter,VK3CA,
was employed by Bail Electronic Services (see
1974 staff photo) from
the late 1960's through to 1977. Following this period he formed
the company GFS Electronic
Imports, of which he
is still a director today.
Any comments on this web site should be directed to the author, Greg Whiter at : GregWhiter@clarkmasts.net.au
|Next Page - Yaesu Musen Co's F-Line of the mid 1960's|
Pages at this site, include: F-Line
of the mid 1960's,
photos, BES 1974 Staff
Cards, FL-50 Magazine
and photos, Photo and details of Yaesu's
first SSB Transceiver, the 1966 released solid state
Shooting Guide is shown HERE,
the 1968 released FTdx400,
Other web articles by the same author The Chronological History of the Development of Radio
Origins Of The Handie Talkie
The History Of Clark Masts
The Early History of GFS Electronics
Copyright © Greg D. Whiter 2010 - All rights Reserved
This page was last updated 29/01/2010
|This page is sponsored by GFS Electronics, Australian distributors of Clark Masts portable air-operated masting, Cobham Mastsystem lightweight portable carbon fibre masts and Debeglass non-conductive guy/catenary wire.|
CLARK MASTS - GENERAL MAST DETAILS